Connecting your TL-150 to the Virtual Monitoring Server

The TL-150 IP communicators from DSC require very little programming. Once wired into the KEYBUS terminals and powered up the TL-150 automatically enrolls itself with your DSC panel.

Go to the DSC test page at http://www.dsc.com/iptesting/ and setup your T-Link with an IP address of 209.82.42.121 and port number 3061. Enter any 4 digit account code into your T-Link and DSC panel. Prefix the account code with zeros in your panel programming. Carry out some tests and if possible, test every device on your system to make sure they all communicate correctly with the server.

Programming your DSC TL-150

1. Enter "tl-150" into the URL bar of your browser and enter the username of "admin" and pasword "admin" when requested in order to access the web interface of the device.

2. From the main page, choose the "Config" hyperlink in the top right corner and you will be presented with a number of programmable options. The options will vary slightly depending on your firmware version.

3. DRL-IP Reporting Address. Enter the IP address provided to you by youralarm.com.

4. Test Transmission Period. Set this to zero as there are problems with the Tl150 firmware.

5. Enable Network Supervision. Remove the tick as there are problems with the Tl150 firmware when enabled.